| 廖生温,唐铃凤,阮晓伟.基于Moldflow的塑料管接头注塑模设计[J].井冈山大学自然版,2011,(2):87-91 |
| 基于Moldflow的塑料管接头注塑模设计 |
| THE PLASTIC PIPE JOINTS INJECTION MOLDING DESIGN ON MOLDFLOW |
| |
| DOI： |
| 中文关键词: Moldflow 塑料管接头 CAE 最佳浇口 模具设计 |
| 英文关键词: Moldflow plastic pipe joints CAE best runner mould design |
| 基金项目:安徽省“十一五”科技攻关项目(06012095B); 安徽省高校自然科学基金项目(2009KJB042) |
|
| 摘要点击次数: 2095 |
| 全文下载次数: 0 |
| 中文摘要: |
| 为缩短注塑产品模具设计的开发周期、提高产品的经济效益以及使产品得到更加合理的模具结构方案。运用Moldflow对塑料管接头进行CAE分析。通过对充填、流动、保压及锁模力的模拟分析,预测塑件可能出现的缺陷并加于修改。得到的结果如下:最小纵横比为1.159,最大纵横比为14.076;充填时速度压力在3.74s时开始切换,最大流动速率为10.74cm3/s,整个充填阶段在3.863s内完成,在3.74s处出现充填过程中最大压力为0.68Mpa,锁模力峰值为0.22tonne在4.53s处出现。 |
| 英文摘要: |
| In order to shorten injection mold design of products,improve the product development cycle of economic benefits and make products to be more rational mould structure scheme.The integrative CAE analysis for plastic pipe joints by using Moldflow software.Through the filling,flow,the pressure and the clamping force simulation analysis,forecast the potential defects plastic parts and add in modification.The results are as follows:the minimum aspect ratio is 1.159,The maximum aspect ratio is 14.076.When filling... |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
